Operation Check(Using The Sgx-Ca500 Only) - Pioneer SGY-PM910H2 Installation Manual

7 Operation Check(Using the SGX-CA500 only)

Using the pedaling monitor mode only：•
After Completing 3.3Magnet Calibration and 5Zero Calibration ride the bicycle to confirm that the Pedaling Vectors are
shown correctly on the CycloComputer Display.
If the Vector directions are not correct, it is possible that Magnet Calibration was not done correctly, so try again.
If the Vectors are not shown, check if the sensors are in Power Meter Mode.
OK Calibration Successful
NG
It is not performed magnet calibration even once
NG Calibration Unsuccessful
NG
While entering the magnet calibration
21