Preparations; Confirm The Products; Outline Of Procedure; For The Sgy-Pm910Hl/Hr With An Ant+ Cycle Computer - Pioneer SGY-PM910H2 Installation Manual

1 Preparations

1.1

Confirm the products

The operations necessary to install the Pedaling Monitor System on the customer's bicycle depend on which System it
is; SGY-PM910HL/HR or SGY-PM910H2, and on which cycle computer is being used; SGX-CA500, SGX-CA900, or
some other manufacturer's product.
1.2

Outline of procedure

1.2.1

For the SGY-PM910HL/HR with an ANT+ cycle computer

Single Power Meter Mode:（SGY-PM910Hl/HR Factory Default Mode）
1. [3.1Temporarily affix the Magnet]: Attach the magnet to the frame temporarily.
2. [2.2.1.3 Check the Current Mode]: Remove then replace the magnet, and observe the LED. It should flash
Orange for ten seconds
3. [3.2 Magnet Detection]: Confirm that the magnet can be detected.
Within five minutes of replacing the battery, rotate the crank and confirm that the LED flashes when passing the
magnet.
4. ［3.3.3 Fixing the Magnet］: Fix the magnet in place.
5. [4 Pairing with the Cyclocomputer]: Pair the sensor with the cycle computer.
6. [5 Zero Calibration]: Carry out Zero Calibration.
1.2.2

For the SGY-910H2/(HL+HR) with an ANT+ cycle computer

Dual Power Meter Mode:（SGY-PM910H2 Mode on shipment from Installation center）
1. [3.1Temporarily affix the Magnet]: Attach the left and right magnets to the frame temporarily.
2. [2.2.1.3 Check the Current Mode]: Remove then replace the magnet, and observe the LED. It should light
Orange for ten seconds.
3. [2.2 Mode Switching]: If the LED flashed in step 2, it is necessary to switch the mode to Dual Power Meter
Mode.
Push the button on the right side transmitter for two seconds, and the LED will flash quickly in
seconds. While this is happening, release the button and press it again for two seconds. The LED will then light in
Orange for ten seconds.
4. [3.2.2Detecting the Magnet Position]: Confirm that the magnet can be detected.
Within five minutes of replacing the battery, rotate the crank and confirm that the LED flashes when passing the magnet.
5. [3.3.3Fixing the Magnets]: Fix the magnet in place.
6. [4Pairing with the Cyclocomputer]: Pair the sensors with the cycle computer using the device number of the
right side sensor.
7. [5Zero Calibration]: Carry out Zero Calibration.
4
Orange for ten