Pioneer SGY-PM910H2 Installation Manual page 23

Pedaling Monitor
Sensor
SGY-
PM910H2/HL/H
R
Question
Cannot connect to a
cycle computer from
another manufacturer in
Dual PowerMeter Mode.
Cannot switch from Dual
Power Meter Mode to
Single PowerMeter Mode.
After replacing the
batteries, the system does
not return to Pedaling
Mode.
Answer
In Dual Power meter Mode, the
sensor device number uses the
device number of the right side
sensor for both sensors
The SGY-PM910H cannot operate
in Single Power Meter Mode. An
update of the firmware is necessary
in order to use Single Power Meter
Mode.
Firstly, rotate the crank at least
three times to activate it.
The change from Dual Power Meter
Mode to Single Power Meter Mode
must be made with both paired
sensors active It is not possible to
change the mode of a lone sensor.
For the SGY-PM910H2, or an
updated SGY-PM910H, removal of
the battoery does not clear the
mode, the previous mode is
remembered.
23