Enter The Device Number And Tap [ ]; Rotate The Bicycle's Crank Set More Than Three Rotations To Start The Left And Right Transmitters; Tap [Pedaling Monitor]; Add In The Sensor List Of Sgx-Ca500 - Pioneer SGY-PM910H2 Installation Manual

Pedaling monitor sensors
Hide thumbs Also See for SGY-PM910H2:
Table of Contents

Advertisement

2.1.4
Enter the device number and tap [
The device numbers are printed on the right junction box and on the side of the left sensor.
2.1.5
Rotate the bicycle's crank set more than three rotations to start the left and right
2.1.6

Tap [Pedaling Monitor].

cannot be received properly. Make sure that the sensor you are pairing is activated, then bring the SGX-CA500 closer to
the sensor and perform the pairing operation again. Pairing with the sensor may not be possible due to interference in the
same frequency band. If "Timeout" is displayed even by operating after moving SGX-CA500 closer to the sensor and
pairing with it, try again someplace where there is no interference from microwaves, radio waves, or wireless equipment.
・Low Battery: The battery is almost empty. Remove the battery and replace with a new one.
].
transmitters.
•Pair with the Cyclocomputer within 5 minutes after the transmitters are
activated.
The search for the sensor starts. A [Please wait.] message appears.。
•It may take more than 1 minute to pair with the sensor.
The mode switching completion screen opens. Tap OK if you want to add in
the sensor list.

2.1.7 Add in the sensor list of SGX-CA500

If you do not add the sensor in the sensor list, the SGX-CA500 will not pair
with the sensor.
You can add the sensor in the sensor list later, using the [Sensors] menu.。
When the mode is switched, the LEDs of the sensors light green for 10
seconds. When it is added in the sensor list, it pairs with SGX-CA500.
Hereafter, whenever the sensor is started, it will automatically pair with
SGX-CA500.
To confirm the sensor list, press the menu button on the left of the product
on the main screen of the CycloMeter and tap [Sensors]. The display on the
mode switching completion screen is as follows depending on the status.•
[Success]
Mode is switched.
[Timeout]
Sensor is not found.
[Cancel]
Cancel is pressed.
[Low Battery] The battery is almost empty.
• Timeout: Communication status is likely to be poor. Sensor information
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sgy-pm910hlSgy-pm910hr

Table of Contents