Pioneer SGY-PM910H2 Installation Manual page 24

Cyclecomputer
Question
There is no menu for
switching modes.
It is not possible to switch
modes using the SGX-
CA500. The display shows
[Timeout].
It is not possible to switch
modes using the SGX-
CA500. The display shows
[Low Battery].
In Magnet Calibration
Mode on the SGX-CA500,
the count does not rise
even though the crank is
rotated.
In Magnet Calibration
Mode on the SGX-
CA500,, the message
[Rotate the crank slowly
in the forward direction] is
displayed.
Answer
Update the SGX-CA500
cyclecomputer to the latest firmware
version. The menu should then be
available under [Options] ->
[Pedaling Settings] -> [Mode
Switching]
The SGY-PM910H sensors are not
capable of Mode Switching. Please
update their firmware in the sensors
to the latest version.
Check the Device ID numbers of
both sensors.
It is necessary to activate the
sensors before attempting to switch
modes. Rotate the crank at least
three times to activate the sensors.
Check the positions of the magnets.
If Magnet Calibration has not been
done yet, temporarily attach the
magnets.
Replace the batteries in the sensors.
Check the LED operation after
inserting new batteries.
The SGY-PM910H is not capable of
Magnet Calibration from the SGX-
CA500. Update the firmware to the
latest version.
It is necessary to activate the
sensors before doing Magnet
Calibration. Attach the Magnets
temporarily, and rotate the crank at
least three times.to activate the
sensors, then carry out Magnet
Calibration.
Check the Device ID Numbers on
each sensor.
Check the position, direction and
distance to te sensor for each
Magnet.
Rotate the crank slowly in the
forward direction. Rotating backward
will interfere with the calibration
operation, and correct calibration will
not be possible..
24