Pioneer SGY-PM910H2 Installation Manual page 25

Cyclecomputer
Question
In Magnet Calibration
Mode on the SGX-CA500,
the results of the
calibration cannot be
stored.
The SGY-PM910HL or
910HR only shows vector
data for one side.
The sensor firmware
cannot be updated.
Answer
Once the count increasing with
each rotation has been confirmed,
with the magnets attached
temporarily, Fix the magnets in place
and press the [Measure] button. The
display will show the count as 0/5.
Rotate the crank until the display
count is shown as 5/5, then the
[Save] button will become available.
Magnet Calibration must be
completed within thirty minutes. If it
is not, the system will revert to
normal mode. Use the [Back] button
to end the Magnet Calibration Tool
then start again. Removing or
replacingthe battery also causes
Magnet Calibration Mode to be
released.
It is necessary to set up the Pedal
Copy function in the SGX-CA500.
With the 910HL, copy Left to Right,
with the 910HR, copy the Right side
to the Left.. [Options] -> [Pedaling
Settings] -> [Pedal Copy]. If this
cannot be found in the menu, please
update the SGX-CA500 cycle
computer firmware to the latest
version.
Check the firmware version in
[Options] -> [Pedaling Settings] ->
Sensor Firmware Version] If this
cannot be found in the menu, please
update the SGX-CA500 cycle
computer firmware to the latest
version.
Update an take up to fifteen minutes
to complete.
25