Switch To Single Power Meter Mode; Method 1] Switch By Pushing The Push Switch In The Right Transmitter; Method 2] Switch The Sensor Mode From Sgx-Ca500 - Pioneer SGY-PM910H2 Installation Manual

2.3

Switch to single power meter mode

・If the actual sensor mode is pedaling monitor mode, switch it on SGX-CA500.
・The firmware version of SGX-CA500 needs to be 20150501.02.43 or higher. If it is of
a different version, update the firmware. Refer to the User's Guide (For WEB) of SGX-CA500 regarding how to update.
http://pioneer-cyclesports.com/us-en/support/products/
The mode can be switched in two ways. Select according to the actual sensor mode.

[Method 1] Switch by pushing the push switch in the right transmitter

[Method 2] Switch the sensor mode from SGX-CA500

2.3.1 [Method 1] Switch by pushing the push switch in the right transmitter
・When using a Cyclocomputer from another manufacturer, switch with this method.
・When it is in the dual power meter mode, if the left and right transmitters are not started, the mode cannot be switched
to the single power meter mode.
Rotate the crank set of the bicycle and start the sensor. When it is in dual power meter mode, if you push the push switch
in the right transmitter for more than 3 seconds, the mode changes to single power meter mode and the LEDs blink
orange for 10 seconds.
When the LEDs blink red, the left transmitter may not have started. Start it again.
When the sensor is in pealing monitor mode, it does not change to the single
power meter mode, even on pushing the push switch. Switch using method 2.
2.3.2 [Method 2] Switch the sensor mode from SGX-CA500
If the mode is pedaling monitor mode or dual power meter mode, switch using the SGX-CA500.
Go to the mode switching screen. Check the sensor you want to use, then select single power and switch the mode.
For how to pair with the cyclocomputer.
When the mode is switched, the LEDs of the sensors blink orange for 10 seconds.
11