Troubleshooting - Pioneer SGX-CA500 User Manual

Hide thumbs Also See for SGX-CA500:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Troubleshooting

EN
If you have problems with your device, check the following items. If you cannot find a solution to your problem here, contact your
dealer.
Will not power up.
The battery is not charged.
The temperature of the device may be too high or low.
The battery goes dead soon after it is charged or the message "Shutdown" appears and power turns off
when the [START/STOP] button is not pressed.
The battery charge is low.
The built-in battery is dead.
The screen brightness setting is too high.
The Wi-Fi connection is turned on.
The operation button or the touch panel is not responding.
There are numerous possibilities for non-operation.
The touch panel is not responding.
The touch panel cannot sense your input.
The touch panel is locked.
You do not know how to initialize.
Sensor information is not displayed.
The sensor is not paired.
The sensor battery is almost empty.
Or the battery is not loaded in the sensor correctly.
58
Cause
Cause
Cause
Cause
Cause
-
Cause
Solution
Charge the battery.
Ü Charging the Device (page 6)
Wait until the device is within standard operating temperature
ranges.
Ü Charging the Device (page 6)
Solution
Charge the battery.
Ü Charging the Device (page 6)
Contact your dealer.
A high screen brightness setting can cause the battery to run
down quickly. To conserve battery power, use a lower screen
brightness setting.
Ü Changing Screen Brightness (page 28)
The Wi-Fi connection can cause the battery to run down
quickly. To conserve battery power, turn off the Wi-Fi
connection.
Ü Wi-Fi Settings (page 44)
Solution
Push the [START/STOP] button and [LAP] button at the same
time for more than 10 seconds to try the forced reset.
Do not do a forced reset if the device has no malfunction.
Solution
The device has a resistive touch panel. Resistive touch
panels require a stronger touch than capacitive touch panels.
Press the [MENU] button to unlock. A message appears when
it unlocks.
Solution
Tap [Settings]-[System]-[Setting Manager]-[Initialize] from the
home screen to initialize.
Ü Initialize (page 53)
If you initialize, the ride log data will be deleted. Save the data
to a PC before initialization.
Solution
Check that the sensor is paired to the device properly. If you
use the pedaling monitor sensor SGY-PM910H/PM900H,
refer to the User's Manual of the SGY-PM910H/PM900H and
Installation Manual.
Replace the battery with a new one.
Or check to make sure that the battery is correctly loaded in
the sensor.
For details about how to replace and load the sensor battery,
refer to the sensor user's manuals.

Advertisement

Table of Contents
loading

Table of Contents