Checking Operation Of The Sensors - Pioneer SGY-PM910H Installation Manual

Checking Operation of the Sensors

Before installing the sensors, confirm that they operate correctly.
1
Remove the right transmitter's cover.
Use a hex wrench (2 mm) to loosen the screw and remove the cover.
•
Be careful not to lose the removed screw.
2
Remove the left transmitter's cover.
Turn the cover to the left so the triangular arrow points to [OPEN] and remove it.
•
Be careful not to drop or lose the battery when removing the cover.
3
Remove the batteries to check the conditions of the LEDs.
Left side
•
After removing the batteries, do not re-install immediately, wait at least one minute and then install them again.
4
Install the batteries, and confirm that the LEDs light green for 10 seconds.
•
Right transmitter: Install the battery. However, do not install the battery cover at the moment, so you can check the LED.
•
Left transmitter: After installing the battery, place the cover with the triangular arrow pointing to [OPEN], and turn it with
coin to [CLOSE].
Left side
•
Be careful not to drop or lose the battery when installing it.
•
Do not use batteries other than CR2032.
• Install the cover firmly to ensure water resistant performance.
Right side
Right side
EN
7