Pre-Assembly - Teeter Power VI Assembly Instructions Instructional Training Manual

PRE-ASSEMBLY

Before you begin: These instructions will guide you in properly assembling the Power VI
all the steps before beginning assembly. Carefully adhere to the Assembly Instructions and Instructional Training Manual to
help ensure user safety and product integrity.
1. Failure to assemble and/or use the equipment as directed may void the manufacturer's warranty on this product and could
result in injury or death.
2. It is your responsibility to familiarize yourself with the proper use of the equipment and the inherent risks of inversion, such
as falling on your head or neck, pinching, entrapment or equipment failure.
3. Do not use the Power VI
accompanying documents, and inspected the equipment.
4. Choose a level surface for assembling and operating the Power VI
5. Follow each step in sequence. Do not skip ahead.
6. Make sure that all fasteners are secure.
7. Replace defective components immediately and/or keep the equipment out of use until repair.
8. Schedule daily, weekly and monthly equipment inspections. Make sure that the parts rotate smoothly and that all fasteners
are secure.
Carefully remove the individual parts from the carton. You should have all of the items listed below. If any items are
missing or damaged, contact your retailer or the manufacturer directly (See Pg. 4 of the Instructional Training Manual).
TM
Power VI Assembly Instructions
ASSEMBLY INSTRUCTIONS
!
TM until you have thoroughly and carefully read the Instructional Training Manual, reviewed all other
ITEMS FOR ASSEMBLY
Bed Frame Assembly
Chain with Manual Crank
Main Shaft w/ Gravity Lock
Two (2) Locking Knobs
Frame Base
Six (6) flat washers
Six (6) threaded bolts
Two (2) Handles
Required tools: 19mm wrench (3/4") and/or adjustable wrenches
* some hardware may arrive pre-assembled to the corresponding parts
Bed Frame Assembly
P12001
Chain w/ Manual Crank
P15004
WARNING
TM .
ITEM #'s
P12001
P15004
P19521
P11003
P12002
H11601
(12mm)
H11600
(12mm)
P12003
Locking Knobs
P11003
Arrive pre-
assembled in
the Main Shaft
Main Shaft w/ Gravity Lock
P19521
Frame Base
P12002
Inversion Table. Please review
TM
Threaded Bolts
H11600
Handles
P12003
Washers
H11601
#LP-9526 Pg. 1