Reboot Switch; Factory Defaults - HP PS1810 Management And Configuration Manual

Diagnostics

Reboot Switch

Click Apply to save any changes for the current boot session; the changes take effect immediately.
Reboot Switch
Use this feature to perform a software reboot of the switch. If you applied configuration changes, wait
at least one minute before rebooting to ensure that the changes are saved to the system configuration
file.
To display the Reboot Switch page, click Diagnostics > Reboot Switch.
Figure 9-3. Reboot Switch Page
Click Reboot Switch to reboot the switch.

Factory Defaults

Two configuration files are kept in system memory: one contains custom settings; the other contains
the factory defaults. Use this page to restore all settings to the factory defaults.
To display the Factory Defaults page, click Diagnostics > Factory Defaults.
C a u ti o n
Backup the current configuration file prior to restoring the factory defaults configuration. See "Backup
Manager" on page 10-1 for instructions.
Figure 9-4. Factory Defaults Page
Click Reset Configuration to reset the system to its default settings for everything except the IP settings.
9-3