Jumbo Frames - HP PS1810 Management And Configuration Manual

Switching

Jumbo Frames

Table 4-1. Port Configuration Fields
Field
Interface
Physical Type
Link Status
Admin Mode
Link Speed
Click Apply to save any changes for the current boot session; the changes take effect immediately.
To view a summary of port information, click Status > Port Summary in the navigation pane.
Jumbo Frames
Use the Jumbo Frames page to enable the switch to forward jumbo Ethernet frames. The jumbo frames
feature extends the standard Ethernet Maximum Transmission Unit (MTU) from 1518 bytes (1522 bytes
with a VLAN header) to 9216 bytes. If it is enabled, any device connecting to the same broadcast domain
should also support jumbo frames.
This feature is disabled by default.
To display the Jumbo Frames page, click Switching > Jumbo Frames in the navigation pane.
Figure 4-2. Jumbo Frames Page
Table 4-2. Jumbo Frames Fields
Field
Enable Jumbo Frames
Click Apply to save any changes for the current boot session; the changes take effect immediately.
4-2
Description
Select the interface to configure.
Describes the port type (i.e., Copper or Fiber).
Up Down
Displays or to indicate operational status.
Enable access to the port on the network. Clear to disable the port.
Configure the duplex mode and transmission rate for the selected port. (These options may change
depending on the port type.)
Auto—
• The rates and duplex mode will be auto-negotiated.
10HDX—
• 10Mbps, half-duplex
100HDX—
• 100Mbps, half-duplex
10FDX—
• 10Mbps, full-duplex
100FDX—
• 100Mbps, full-duplex
1000FDX—
• 1000Mbps, full duplex (for fiber ports)
Note:
The port's maximum capability is advertised.
Description
Enable the switch to forward jumbo frames up to 9216 bytes.