Reboot Switch; Factory Defaults - HP 1820 Management And Configuration Manual

Diagnostics

Reboot Switch

Reboot Switch
Use this feature to perform a software reboot of the switch. If you applied configuration changes, click the Save
Configuration button in the upper right of any page before rebooting. If the switch is configured to use DHCP
to acquire its IP address, the address may change upon restart; you will need to determine the address before
logging back in to the management utility.
To display the Reboot Switch page, click Diagnostics > Reboot Switch.
Figure 11-4.Reboot Switch Page
Click Reboot to reboot the switch.

Factory Defaults

You can use the Reset Configuration page to restore all settings to their factory default values. All configuration
changes, including those that were previously saved, are reset in the running system by this action.If the switch
is configured to use DHCP to acquire its IP address, the address may change upon restart; you will need to
determine the address before logging back in to the management utility.
To display the Factory Defaults page, click Diagnostics > Factory Defaults.
Caut ion
It is recommended that you back up the current configuration file prior to restoring the factory defaults
configuration. See
Figure 11-5.Reset Configuration Page
Click Reset to restore the system to the default settings.
11-6
"Backup and Update Manager" on page 12-2 for instructions.