Advanced Screen; Ipv6 Screen - ZyXEL Communications NBG-418N User Manual

7.4 Advanced Screen

Use this screen to set up multicast configurations. Click Network > WAN > Advanced.
Figure 60 Network > WAN > Advanced
The following table describes the labels in this screen.
Table 35 Network > WAN > Advanced
LABEL
Multicast Setup
Multicast Proxy
Multicast Snooping
Auto IP Setup
Enable Auto-IP-
Change mode
Apply
Reset

7.5 IPv6 Screen

Use this screen to configure your IPv6 settings. Click Network > WAN > IPv6.
Chapter 7 WAN
DESCRIPTION
Click the Multicast Proxy radio button to enable this function on the NBG-418N v2.
This allows an IPv6 router to discover the presence of MLD hosts who wish to receive
multicast packets and the IP address of multicast groups the hosts want to join on its
network.
Click the Multicast Snooping radio button to activate it. This allows the NBG-418N v2
to check MLD packets passing through it and learn the multicast group membership. It
helps reduce multicast traffic.
Click Enable Auto-IP-Change mode button to have the NBG-418N v2 change its LAN
IP address to 10.0.0.1 or 192.168.1.1 accordingly when the NBG-418N v2 gets a
dynamic WAN IP address in the same subnet as the LAN IP address 192.168.1.1 or
10.0.0.1.
The NAT, DHCP server and firewall functions on the NBG-418N v2 are still available in
this mode.
Click Apply to save your changes back to the NBG-418N v2.
Click Reset to begin configuring this screen afresh.
NBG-418N v2 User's Guide
84