ZyXEL Communications NBG-418N User Manual page 93

The following table describes the labels in this screen.
Table 41 Network > WAN > IPv6 (6 to 4)
LABEL DESCRIPTION
IPv6 Connection 6 to 4 is an IPv6 address assignment and automatic tunneling technology that used to
Type provide unicast IPv6 connectivity between IPv6 sites and hosts across the IPv4 Internet.
6to4 Settings
6to4 Address
6to4 Relay Type the ISP's border relay server's IPv6 address in this field.
IPv6 DNS Settings
Primary/Secondary Enter the first/second IPv6 DNS server address assigned by the ISP.
DNS Address
Lan IPv6 Address Settings
LAN IPv6 Address This field is not configurable when you set the IPv6 Connection Type to 6to4, 6rd or
Link-local only.
LAN IPv6 Link-Local This shows the IPv6 Link-local address in the LAN side. This is used by routers when
Address communicating with neighboring devices on the same link. It allows IPv6-capable
devices to communicate with each other in the LAN side.i
Address Autoconfiguration Settings
Enable Click Enable Autoconfiguration if you want the devices on your local area network to
Autoconfiguration obtain network address that are not managed by a DHCPv6 server.
Autoconfiguration Select SLAAC + Stateless DHCPv6 if you want the interface to automatically generate
Type a link-local address via stateless autoconfiguration.
Select Stateful(DHCPv6) when the devices connected to your LAN needs to have their
TCP/IP configuration set to DHCPv6 or obtain an IPv6 address automatically.
Router If you select SLAAC + Stateless DHCPv6, type in the Router Advertisement
Advertisement Lifetime which is amount of time in minutes that a device may have an IPv6 address
Lifetime before it is required to renew the lease.
IPv6 Address If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
Range(Start) DHCPv6 server assigns to the clients. Enter the smallest value of the last block of the
IPv6 addresses which are to be allocated.
IPv6 Address If you select Stateful (DHCPv6), specify the range of IPv6 addresses from which the
Range(End) DHCPv6 server assigns to the clients. Enter the largest value of the last block of the
IPv6 addresses which are to be allocated.
IPv6 Address If you select Stateful (DHCPv6), specify how long (in minutes) the IPv6 addresses
Lifetime remain valid.
Apply Click Apply to save your changes back to the NBG-418N v2.
Reset Click Reset to begin configuring this screen afresh.
Chapter 7 WAN
NBG-418N v2 User's Guide
93