Static Dhcp Screen - ZyXEL Communications NBG-418N User Manual

Figure 71 Network > DHCP Server > General
The following table describes the labels in this screen.
Table 44 Network > DHCP Server > General
LABEL
DHCP Mode
IP Pool Range
Max Lease Time
DNS Sever1
DNS Sever2
Apply
Reset

9.5 Static DHCP Screen

This screen allows you to assign IP addresses on the LAN to specific individual computers based on
their MAC addresses. You can also use this screen to configure the DNS server information that the
NBG-418N v2 sends to the DHCP clients.
To change your NBG-418N v2's static DHCP settings, click Network > DHCP Server > Static
DHCP. The following screen displays.
Chapter 9 DHCP Server
DESCRIPTION
Select DHCP server from the drop-down list to have the NBG-418N v2 act as a DHCP
server. Otherwise, select None. DHCP (Dynamic Host Configuration Protocol, RFC
2131 and RFC 2132) allows individual clients (computers) to obtain TCP/IP
configuration at startup from a server. Choose DHCP Server option unless your ISP
instructs you to do otherwise. Choose None to disable the NBG-418N v2 acting as a
DHCP server. When configured as a server, the NBG-418N v2 provides TCP/IP
configuration for the clients. If not, DHCP service is disabled and you must have
another DHCP server on your LAN, or else the computers must be manually
configured. When set as a server, fill in the following four fields.
This field specifies the range of the contiguous addresses in the IP address pool for
LAN.
This field specifies the Maximum time interval the device can be idle before the IP
address on the LAN link is disconnected. Default is 120 minutes, maximum is 525600
minutes
Type the First DNS server IP address of the DHCP server.
Type the Second DNS server IP address of the DHCP server.
Click Apply to save your changes back to the NBG-418N v2.
Click Reset to begin configuring this screen afresh.
NBG-418N v2 User's Guide
101