Ds-Lite - ZyXEL Communications NBG-418N User Manual

Table 33 Network > WAN > Internet Connection: PPTP Encapsulation (continued)
LABEL
Clone the
computer's MAC
address - MAC
Address
Set WAN MAC
Address
Apply
Reset

7.3.4 DS-Lite

Use Dual Stack Lite when local network computers use IPv4 and the ISP has an IPv6 network. The
NBG-418N v2 tunnels IPv4 packets inside IPv6 encapsulation packets to the ISP's Address Family
Transition Router (AFTR) to connect to the IPv4 Internet. The local network can also use IPv6
services. The NBG-418N v2 uses it's configured IPv6 WAN IP to route IPv6 traffic to the IPv6
Internet.
This screen displays when you select DS-Lite as the Connection Type.
Figure 59 Network > WAN > Internet Connection: DS-Lite
The following table describes the labels in this screen.
Table 34 Network > WAN > Internet Connection: DS-Lite
LABEL
ISP Parameters for Internet Access
Connection Type Select DS-Lite to tunnel IPv4 packets inside IPv6 encapsulation packets to the ISP's
DS-Lite Mode
AFTR Name or
Address
Apply
Reset
Chapter 7 WAN
DESCRIPTION
Select this option to clone the MAC address of the computer (displaying in the screen) from
which you are configuring the NBG-418N v2. Once it is successfully configured, the address
will be copied to the rom file. It will not change unless you change the setting or upload a
different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the NBG-418N v2.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Address Family Transition Router (AFTR) to connect to the IPv4 Internet when local network
computers use IPv4 and the ISP has an IPv6 network.
You can only set the IPv6 connection type to Static IPv6, SLAAC/DHCPv6 or PPP over
Ethernet in the Network > WAN > IPv6 screen.
Select DS-Lite DHCPv6 to obtain the AFTR information automatically using DHCPv6.
Select Manual to configure the AFTR address manually.
Enter the domain name or IPv6 address of the Address Family Transition Router (AFTR).
Click Apply to save your changes back to the NBG-418N v2.
Click Reset to begin configuring this screen afresh.
NBG-418N v2 User's Guide
83