Clutch Cleaning And Maintenance - Yukon Trail Badger 100 Owner's Manual

CLUTCH CLEANING AND MAINTENANCE

After every 5 hour of use, your clutch will need cleaning and
lubrication. If clutch becomes too dirty or has lack of lubrication,
the clutch will have a tendency to stick. This will cause the
Mini-Bike to want to take off before throttle is applied.
To clean and lubricate clutch, follow the instructions below:
1. Make sure engine is turned off and engine is cool before
removing clutch cover.
2. Remove Clutch Cover
3. With compressed air, blow through holes to remove any dust
and/or particles.
4. Oil Clutch bearing with a few drops of 30W motor oil Note:
Make sure oil does not get inside clutch itself.
5. Push Mini bike forward without starting allowing oil to flow
through bearing surface.
6. Re-install clutch cover
Starting engine with clutch cover removed could be hazardous
Starting engine with clutch cover removed, increases the chance
of getting your person caught in moving components which could
result in severe injury.
Never start Mini Bike with clutch cover removed.
Blow out clutch with compressed
air through large holes
Clutch Cover
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
Oil Clutch here ONLY