Changing The Oil - Yukon Trail Badger 100 Owner's Manual

INSPECTION AND MAINTENANCE

Changing the Oil

1. Remove the "Screw Plug" located at the bottom of the engine and
let the oil drain into an approved collection container. DO NOT
PERFORM THIS PROCEDURE WHILE THE ENGINE IS HOT. SERIOUS
BURNS COULD RESULT FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures,
contact your local oil recycling center.
3. Clean and replace the "Screw Plug" tightly.
4. Refill the engine with the proper amount of oil and recheck the
amount of oil in the engine by using the oil gauge plug.
Screw plug for oil draining
CHECK-UP OF SPARK PLUG
1. Remove the cap of spark plug and screw
off the spark plug using the plug
wrench.
2. Clean the spark plug all around or
replace it if it is corroded or there is
too much deposit on it.
3. Regulate the gap of the spark plug
to .7mm - .79mm (.028"-.031").
3. The spark plug of the designated type
should be used. The applicable type of
spark plug: NGK- 6RTF, BM4A, BMR4A
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.
.7mm - .79mm
(.028" - .031")