Changing The Oil; Check-Up Of Spark Plug - Yukon Trail Puma 200 Owner's Manual

CHANGING THE OIL

1. Remove the "Screw Plug" located at the bottom of the engine
and let the oil drain into an approved collection container. DO NOT
PERFORM THIS PROCEDURE WHILE THE ENGINE IS HOT. SERIOUS
BURNS COULD RESULT FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil prope
3 Clean and replace the "Screw Plug" tightly. Torque to 18 ft.lb.
4. Refill the engine with 0.53 qt. (0.5L) of recommended oil and
recheck the amount of oil in the engine by using the oil gauge plug.
Screw plug for oil draining

CHECK-UP OF SPARK PLUG

1. Remove the cap of spark plug and
screw off the spark plug using the plug
wrench.
2. Clean the spark plug all around or
replace it if it is corroded or there is too
much deposit on it.
3. Regulate the gap of the spark plug
to .7mm - .79mm (.028"-.031").
4. The spark plug of the designated type
should be used. The applicable type of spark plug: Meiya - F7RTC
Champion-RN9YC, NGk - BPR6ES
DO NOT RETURN STORE. For questions regarding assembly and use,
call Customer Service: 877-441-6999.