Table of Contents
Advertisement
Step 5: Mount Your SC-T35
To mount your SC-T35 on the back of a monitor, please do the following:
Step 2
Step 4
1. Refer to
and
• You will need two (2) screws of type
• You will need two (2) screws of type
2. Place your SC-T35 on a flat surface with the VESA mount hole side upward.
3. Refer to
Step 2
to choose two of the four VESA mount holes on the bracket to align with two mount holes
on your SC-T35 such that the bracket projects out and is closer to the rear panel than the front one as shown
below, and then secure the bracket to your SC-T35 with two (2) screws of type
4. Align the mount holes on the bracket with the mount holes on the back of the monitor, and then secure the
bracket to the monitor with two (2) screws of type
of the monitor and the rear panel of your SC-T35 is facing rightward as shown below.
2.2 Assembling the AC Adapter
To assemble the AC adapter for your SC-T35, please do the following:
1. Unpack your thin client package and take out the AC adapter
and its detached plug.
2. Slide the plug into the AC adapter until it clicks into place.
NOTE
• The supplied plug may vary, depending on different areas.
to prepare required screws for mounting your SC-T35.
2
to secure the bracket to your SC-T35.
1
2
or
to secure the bracket to the monitor.
2
11
Setting Up Your SC-T35
Assembling the AC Adapter
2
.
1
or
. Ensure that your SC-T35 is located in the center
Have SC-T35's rear panel
facing rightward.
Advertisement
Table of Contents
