Configuring Client Settings
Configuring Network Settings
Stopping a Wireless Network Connection
To stop a wireless network connection, please do the following:
1. On ViewSonic Client Setup, click Network > Wireless to open the Wireless Network list.
2. Click to check the desired wireless network. The Disconnect
Wireless Network list.
3. Click Disconnect to stop the wireless network connection.
Adding a Wireless Network
In case that you cannot find the desired wireless network in the Wireless Network list, you can manually add it.
To add a wireless network to the Wireless Network list, please do the following:
1. On ViewSonic Client Setup, click Network > Wireless to open the Wireless Network list.
2. Click Add on the top of the Wireless Network list.
3. On General tab, type in or click drop-down menus to provide information about configuration and
authentication.
NOTE
• Consult your network administrator for required information on configuration and
authentication.
4. On IPV4 Settings tab, configure the IP address related settings.
NOTE
• For instructions on how to configure the IP address settings, please refer to section
"4.5.3 Configuring Wired Network Settings" on page 77.
• The default is to use a dynamic IP address assigned by the DHCP server.
5. Click Save to add the wireless network.
Deleting a Wireless Network
To delete a wireless network, please do the following:
1. On ViewSonic Client Setup, click Network > Wireless to open the Wireless Network list.
2. Click to check the desired wireless network.
3. Click Delete to remove the selected wireless network.
NOTE
• Your SC-T35 detects available wireless networks automatically and put the
discovered networks on the Wireless Network list. A deleted wireless network may
therefore appear again on the list, but the connection settings, including the stored
authentication data, will be removed.
button appears on the top of the
90