Table of Contents
Advertisement
4.5.9
Configuring Wireless Network Settings
Adjusting Connection settings for a Wireless Network
To adjust connection settings for a wireless network, please do the following:
1. On ViewSonic Client Setup, click Network > Wireless to open the Wireless Network list.
2. Click to check the desired wireless network. The Edit
Network list.
3. Click Edit to adjust the settings, and then click Save to apply.
NOTE
• Two sub-tabs are available: General and IPV4 Settings. For instructions on how
to configure general connection settings on General sub-tab, please refer to
section "4.5.8 Establishing and Stopping a Wireless Connection" on page 88. For
instructions on how to configure IP address settings on IPV4 Settings sub-tab,
please refer to section "4.5.3 Configuring Wired Network Settings" on page 77.
Configuring General Settings for Wireless Network Connections
To configure general settings for wireless network connections, please do the following:
1. On ViewSonic Client Setup, click Network > Wireless, and then click Wireless sub-tab.
2. Under the Interface section, click the drop-down menu to enable/disable the wireless network interface.
3. Under the Connection section, click to check/uncheck Auto connect when startup to allow/disallow
automatic wireless network connection after system startup. When this feature is enabled, select the desired
wireless network through the drop-down menu.
NOTE
• All wireless networks that you ever tried to access by clicking the Connect button on
Connections tab will be listed on the drop-down menu.
Configuring Client Settings
Configuring Network Settings
button appears on the top of the Wireless
91
Advertisement
Table of Contents
