Yamaha Vmax VMX17C 2009 Service Manual page 40

2. Push "RESET".
3. Push "SELECT" to highlight "Stopwatch".
4. Push "RESET".
The multi-function display changes to the
Normal mode and the stopwatch is displayed
in place of the clock.
5. Push "SELECT" to start the stopwatch.
6. Push "SELECT" or the start switch "
stop the stopwatch.
7. Push "RESET" to reset the stopwatch.
TIP
• If neither "SELECT" or "RESET" are pushed for
one minute, the screen automatically changes
to the Normal mode.
• Pushing "RESET" for at least two seconds
changes the screen to the Normal mode.
• To perform further multi-function display set-
tings, enter the Select mode again by pushing
and holding "SELECT" and "RESET" for at
least three seconds.
Using the countdown clock:
The countdown clock can be activated as fol-
lows.
1. Push "SELECT" to highlight "Stopwatch".
2. Push "RESET".
3. Push "SELECT" to highlight "Countdown".
4. Push "RESET". The multi-function display
changes to the Normal mode, the stopwatch
is displayed in place of the clock, and the
transmission gear indicator changes to the
countdown clock.
5. Push "SELECT" or shift into gear and the
countdown clock starts counting down from
"5". Simultaneously, the shift timing indicator
flashes according to the number displayed
(i.e., when "5" is displayed, the indicator
flashes five times, when "4" is displayed, the
indicator flashes four times, etc.). The stop-
watch starts counting when the countdown
clock finishes counting.
6. Push "SELECT" or push the start switch "
" to
to stop the countdown clock.
7. Push "RESET" to reset the countdown clock
and stopwatch.
8. Push "RESET" to reset the countdown clock,
and then repeat steps 5–6, OR push "RE-
SET" again for at least two seconds to enter
the Normal mode.
TIP
To perform further multi-function display set-
tings, be sure the transmission is in neutral,
then enter the Select mode again by pushing
and holding "SELECT" and "RESET" for at least
three seconds.
Checking and resetting the system status
The status/readings of the following items are
displayed, and the tripmeters can be reset.
• tripmeters and odometer
• fuel consumption
• air intake temperature
• throttle opening position
TIP
• The "System status" menu cannot be entered
if the fuel level warning light or coolant temper-
ature warning light is on.
1-31
FEATURES
"