Removing The Swingarm; Checking The Swingarm; Installing The Swingarm - Yamaha Vmax VMX17C 2009 Service Manual

EAS23350

REMOVING THE SWINGARM

1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there is
no danger of it falling over.
TIP
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
2. Measure:
• Swingarm side play
• Swingarm vertical movement
M MMM M MMM M M MMM M M MMM M
a. Measure the tightening torque of the left pivot
bolt, right pivot bolt, and pivot bolt locknut.
Left pivot bolt
100 Nm (10.0 m·kgf, 72 ft·lbf)
Right pivot bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Pivot bolt locknut
100 Nm (10.0 m·kgf, 72 ft·lbf)
b. Measure the swingarm side play "A" by mov-
ing the swingarm from side to side.
c. If the swingarm side play is out of specifica-
tion, check the spacers, bearings, plates, and
oil seals.
Swingarm side play (at the end of
the swingarm)
0 mm (0 in)
d. Check the swingarm vertical movement "B"
by moving the swingarm up and down.
If swingarm vertical movement is not smooth
or if there is binding, check the spacers, bear-
ings, plates, and oil seals.
L LLL L LLL L L LLL L L LLL L
M MMM M M MMM M MMM
B
A
L LLL L L LLL L LLL
4-89
EAS23360

CHECKING THE SWINGARM

1. Check:
• Swingarm
Bends/cracks/damage → Replace.
2. Check:
• Left pivot bolt
• Right pivot bolt
Bends/cracks/damage → Replace.
3. Wash:
• Left pivot bolt
• Right pivot bolt
• Spacers
• Bearings
• Plates
Recommended cleaning solvent
Kerosene
4. Check:
• Plates
• Spacers
• Oil seals
Damage/wear → Replace.
• Bearings
Damage/pitting → Replace.
EAS23390

INSTALLING THE SWINGARM

1. Lubricate:
• Bearings
• Oil seals
• Spacers
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Swingarm
M MMM M MMM M M MMM M M MMM M
a. Temporarily install the left pivot bolt and right
pivot bolt to hold the swingarm in place.
b. Tighten the left pivot bolt.
Left pivot bolt
100 Nm (10.0 m·kgf, 72 ft·lbf)
LOCTITE®
c. Thread the right pivot bolt into the swingarm
until it makes contact with the spacer, and
then tighten the pivot bolt to the specified
torque.
Right pivot bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
SWINGARM
M MMM M M MMM M MMM