Yamaha Vmax VMX17C 2009 Service Manual page 315

Sheave holder
90890-01701
Primary clutch holder
YS-01880-A
3. Apply:
• Sealant
(onto the crankshaft position sensor/stator
assembly lead grommet)
Yamaha bond No. 1215
90890-85505
(Three Bond No.1215®)
4. Install:
• Stator coil
• Crankshaft position sensor
• Crankshaft position sensor/stator assembly
lead holder 1
Stator coil bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
Crankshaft position sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
LOCTITE®
Crankshaft position sensor/sta-
tor assembly lead holder 1 bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
GENERATOR AND STARTER CLUTCH
2
1
3
5-42
TIP
• Route the crankshaft position sensor lead "1"
to the inside of the rib "a" on the generator cov-
er.
• Route the crankshaft position sensor lead un-
der the crankshaft position sensor/stator as-
sembly lead holder "b".
• Make sure that the crankshaft position sensor
lead is routed around the generator cover boss
"c".
• Route the stator coil lead "2" to the inside of the
rib "d" on the generator cover.
1
a
A
5. Install:
• Generator cover gasket
• Generator cover
Generator cover bolt
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
LOCTITE®
TIP
Tighten the generator cover bolts in stages and
in a crisscross pattern.
6. Install:
• Generator cover plate damper
• Generator cover plate "1"
Generator cover plate bolt
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
TIP
• Install the generator cover plate so that the let-
tering in the recycle mark "a" is right side up.
• Tighten the generator cover plate bolts in stag-
es and in a crisscross pattern.
b
c
d
2 A
New