Yamaha Vmax VMX17C 2009 Service Manual page 352

EWA2S31013
WARNING
If the bolt is tightened more than the speci-
fied angle, do not loosen the bolt and then re-
tighten it. Instead, replace the bolt with a new
one and perform the procedure again.
ECA2S31043
NOTICE
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is at the specified
angle.
TIP
On a hexagonal bolt, note that the angle from
one corner to another is 60°.
d. Repeat steps (a) and (b) for each of the
crankcase bolts "2"–"8" in order.
3
7
8
4
L LLL L LLL L L LLL L L LLL L
8. Tighten:
• Crankcase bolts "9"–"42"
1
5
2 6
L LLL L L LLL L LLL
5-79
Crankcase bolt "9"–"27", "31"–
"39"
24 Nm (2.4 m·kgf, 17 ft·lbf)
Crankcase bolt "28"–"30", "40"–
"42"
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
TIP
Tighten the crankcase bolts in the proper tight-
ening sequence as shown.
A
28
18
20
16 17
15
14 10
23
25
30
29
CRANKCASE
27
19
13
9 11
12
21
26
24
22