Safety Information - Martin Stagebar 2 RGBAW User Manual

Safety Information

The following symbols are used to identify important safety information on the product and in this manual:
Warning!
Safety hazard.
Risk of severe
injury or death.
WARNING! Risk Group 3 LED product according to EN 62471. Do not look into the beam at a
distance of less than 8.7 meters (28 ft. 7 ins.) from the front surface of the product. Do not view the
light output with optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture. If you have questions about how to
operate the fixture safely, please contact your Martin™ dealer or call the Martin 24-hour service hotline at
+45 70 200 201.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Shut down power to the entire installation at the building's main power distribution board and lock out
power (by removing the fuse for example) before carrying out any installation or maintenance work.
• Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
• Always ground (earth) the fixture electrically.
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Connect this fixture to AC power via 3-conductor cable that is heat resistant to minimum 90° C (194° F)
and rated minimum 13 amp. In North America the cable must be minimum 16 AWG, extra hard usage
type (STW or equivalent). In the EU the cable must be minimum 1.5 mm
approved or equivalent.
• Cables used for power throughput must meet the same specifications as those given above for power
input cables.
• The voltage and frequency at the power throughput outlet are the same as the voltage and frequency
applied to the power inlet. Only connect devices to the power outlet that accept this voltage and
frequency.
• The total current draw of all the devices connected to the power throughput outlet of the first fixture in a
chain must not exceed 11 amps.
Read the safety precautions in this section before
installing, powering, operating or servicing this
Warning!
LED light
emission. Risk
of eye injury.
WARNING!
product.
Warning! Warning!
Refer to Hazardous
manual before voltage. Risk of
installing, lethal or severe
powering or electric shock.
servicing.
Warning!
Fire hazard.
2
conductor size and HAR