Table of Contents
Advertisement
Safety Information
Read the safety precautions in this section before
installing, powering, operating or servicing this
The following symbols are used to identify important safety information on the product and in this manual:
WARNING!
Safety hazard.
Risk of severe
injury or death.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
Read this manual before installing, powering or servicing this product, follow the safety precautions listed
below and observe all warnings in this manual and printed on the product.
If you have questions about how to operate the EC Series system safely, please contact your Martin supplier
or call the Martin 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Connect the product to AC mains power within the range 200-240 V nominal at 50 or 60 Hz only.
• Disconnect the entire installation from power and ensure that power cannot be reconnected, even
accidentally, before carrying out any installation or maintenance work.
• Double-pole/neutral fusing is used. If the installation is not completely disconnected from power, parts
may remain live even if one of the two mains fuses has blown.
• Disconnect the product from power when not in use.
• Always ground (earth) the product electrically.
• Use only a source of power that complies with local building and electrical codes. Power distribution
circuits must be fitted with a current overload fuse or circuit breaker with a maximum rated current of 40 A
for European region and with a maximum rated current of 32 A for North American region, and
ground-fault (earth-fault) protection of high breaking capacity (≥1500 A).
• Connect the Header to power using only the cables supplied by Martin for this product.
• Protect power cables from water and rain.
• Connect the Header to power using only 32 amp-rated industrial Type B power plugs and socket outlets
that comply with IEC 60309 (or a comparable national standard) and provide an electrical connection to
ground (protective earth).
• External power switches or socket outlets used to supply Headers with power must be located near the
product and easily accessible so that the product can easily be disconnected from power.
• Do not connect any other device than EC Series panels to the power throughput connector in the base of
the product.
• Connect no more than sixteen EC Series panels in total to power in one chain using the power throughput
connectors in the base of the product.
4
WARNING!
WARNING!
Refer to
Hazardous
manual before
voltage. Risk of
installing,
lethal or severe
powering or
electric shock.
servicing.
EC Series user manual
WARNING!
product.
WARNING!
WARNING!
Hot surface. Do
Fire hazard.
not touch.
WARNING!
Emission
hazardous to
eyesight.
Advertisement
Table of Contents
