Replacing; Disconnecting And Reconnecting - Skoda Yeti 2015 Operating Instructions Manual

Hide thumbs Also See for Yeti 2015:
Table of Contents

Advertisement

Attach the terminal clamps of the charger to the battery terminals (red =
"positive", black = "negative").
Plug the mains cable of the charger into the power socket and switch on the
device.
After charging has been successful: Switch off the charger and remove the
mains cable from the power socket.
Only then disconnect the charger's terminal clamps.
Reconnect the cables to the battery (first "positive", then "negative").
Charging with low voltages
It is not necessary to disconnect the cables from the battery if you recharge
the vehicle battery, for example from a mini-charger.
Refer to the instructions of the charger manufacturer.
A charging current of 0.1 multiple of the total vehicle battery capacity (or low-
er) must be used until full charging is achieved.
The vent plugs of the vehicle battery should not be opened for charging.
WARNING
When you charge a battery, hydrogen is released, and a highly explosive
gas mixture is also produced. An explosion can be caused through sparkling
over during unclamping or loosening of the cable plug while the ignition is
on.
Creating a bridge between the poles on the battery (e.g. with metal ob-
jects - cables) creates a short circuit - risk of damage to the battery, explo-
sion and burning of the battery, jets of acid spurting out.
Avoid creating sparks when working with cables and electrical devices.
Strong sparking represents a risk of injury.
Before carrying out any work on the electrical system, switch off the en-
gine, the ignition and all electrical consumers and disconnect the negative
terminal .
"Quick-charging" the vehicle battery is dangerous and requires a special
charger and specialist knowledge.
We therefore recommend that vehicle batteries be "rapidly charged" by a
specialist garage.
CAUTION
On vehicles with the START / STOP system or additional heating (auxiliary
heating), do not connect the pole terminal of the charger directly to the nega-
tive terminal of the vehicle battery but only to the engine earth

Replacing

Read and observe
The new vehicle battery must have the same capacity, voltage, current and the
same size as the original Battery. Suitable vehicle battery types can be pur-
chased from a specialist garage.
We recommend having the battery replaced by a specialist garage, where the
new vehicle battery will be installed properly and the original battery will be
disposed of in accordance with national regulations.

Disconnecting and reconnecting

Read and observe
Disconnecting
Switch off the ignition.
Disconnect the negative terminal  first and then the positive
the battery.
Connecting
Connect the positive terminal
After disconnecting and re-connecting the vehicle battery, the following func-
tions or devices are partially or completely inoperative.
Function / device
Electrical power windows
Panorama sliding/tilting roof
Sun screen
Radio or navigation system
Time settings
CAUTION
Disconnect the vehicle battery only with the ignition turned off - there is a
risk of damaging the electrical system of the vehicle.
Under no circumstances must the battery cables be connected incorrectly –
» page
191.
risk of a cable fire.
and
on page 173 first.
and
on page 173 first.
first, then the negative battery terminal.
Operating measure
» page 63
» page 64
» page 65
Enter code number
manual ,
»
Infotainment radio
manualor
»
gation manual
» page 32
Inspecting and replenishing
terminal of
»
Radio
Infotainment navi-
175

Advertisement

Table of Contents
loading

Table of Contents