Automatic Transmission - Skoda Yeti 2015 Operating Instructions Manual

Hide thumbs Also See for Yeti 2015:
Table of Contents

Advertisement

Manual gear changing
On the shift lever, the individual gear positions are shown
The gearshift indicator should be observed when changing gear
Always depress the clutch pedal all the way down. This prevents uneven wear
on the clutch.
Reverse gear is engaged
Stop the vehicle.
The clutch pedal is fully depressed.
Move the shift lever to the idle position switch and press down.
Move the shift lever fully to the left and then forward into R position
» Fig.
126.
The reversing lights will come on once reverse gear is engaged, provided the
ignition is on.
WARNING
Never engage reverse gear when driving – risk of accident!
CAUTION
If not in the process of changing gear, do not leave your hand on the gear-
shift lever while driving. The pressure from the hand can cause the gearshift
mechanism to wear excessively.
When stopping on a slope, never try to hold the vehicle using the accelerator
pedal and the clutch pedal – this may lead to damage of the clutch parts.
Pedals
The operation of the pedals must not be hindered under any circumstances!
Fig. 126
The shift pattern
» Fig.
126.
» page
42.
In the driver's footwell, only a format may be used, which is attached to the
two corresponding attachment points.
Only use factory-supplied foot mats or foot mats from the range of
ŠKODAOriginal Accessories, which are fitted to two attachment points.
WARNING
No objects may be placed in the driver's footwell – risk due to obstruction
or limitation of pedal operation.

Automatic transmission

Introduction
This chapter contains information on the following subjects:
Modes and use of selector lever
Selector lever lock
Manual shifting of gears (Tiptronic)
Starting-off and driving
The automatic transmission performs automatic gear changes.
The modes of the automatic transmission can be adjusted by the driver by
means of the selector lever.
WARNING
No throttle when it is set before starting the mode for moving forward
with the selector lever - there is a risk of accident!
Never move the selector lever to mode R or P when driving – risk of an
accident!
If the vehicle is in the mode selected D, S, R or Tiptronic and the engine
stops when at idle speed, then the brake pedal must be pressed. Even
when the engine is idling, the power transmission is never completely in-
terrupted – the vehicle creeps.
When leaving the vehicle, the selector lever is always to put in the P
mode. Otherwise the vehicle could then start to move and potentially cause
an accident.
124
124
125
125
123
Starting-off and Driving

Advertisement

Table of Contents
loading

Table of Contents