Table of Contents
Advertisement
Hazard warning light system
Read and observe
on page 66 first.
The hazard warning lights make other road users aware of your vehicle.
The function switches on all indicators.
Switching on/off
›
Press the button
» Fig.
49.
When you turn it on the warning light
time the warning lights
in the instrument cluster.
The hazard warning light system can also be operated if the ignition is switch-
ed off.
If one of the airbags is deployed, the hazard warning light system will switch
on automatically.
When the hazard warning system is on and the indicator light is switched on
(e.g. when turning), the hazard warning lights are switched off temporarily and
only the turn signal flashes on the relevant side of the vehicle.
Parking lights
Read and observe
on page 66 first.
The side light is provided for lighting of the parked vehicle.
The function switches on the side lights.
Switching on the side light on one side
›
Switch off the ignition.
›
Press the control lever to position
page 67.
70
Using the system
Fig. 49
Button for hazard warning light
system
flashes in the button and at the same
or
as far as the stop
» Fig. 46
A
B
The parking lights on the right or left side of the vehicle are turned on.
Switching on the side light on both sides
›
With the ignition switched on turn the light switch to position .
›
Switch off the ignition.
›
Lock the vehicle.
After pulling out the ignition key and opening the driver's door, an audible
warning sounds.
After a few seconds or after closing the driver's door, the audible alarm is
turned off, but the parking lights will remain switched on.
CAUTION
Turning on the parking light means the battery is heavily loaded.
■
The parking light cannot be turned off automatic due to the low battery
■
charge level.
If the two-sided parking lights are switched on when the ignition is off, then
■
there is no automatic switching off of the parking light.
Instrument lighting
Read and observe
The brightness of the instrument lights can be set only if the parking, low
beam or high beam is switched on.
Turning the knob
» Fig. 50
Adjust brightness of the instrument lighting.
Note
On vehicles with MAXI DOT display
lighting is set automatically. A manual brightness adjustment can therefore
on
only have a limited effect.
Fig. 50
Controls for the instrument
lighting
on page 66 first.
» page 45
the brightness of the instrument
Advertisement
Chapters
Table of Contents
