Handbrake; Brake System; Seat Belt Warning Light; Alternator - Skoda Yeti 2015 Operating Instructions Manual

Hide thumbs Also See for Yeti 2015:
Table of Contents

Advertisement

Handbrake

Read and observe
on page 34 first.
illuminates - the hand brake is applied.
An acoustic signal will sound if you drive the vehicle above 6 km/h for at least
3 seconds while the handbrake is applied.
Release parking brake!

Brake system

Read and observe
on page 34 first.
illuminates - the brake fluid level in the braking system is too low.
Brake fluid: Owner's manual!
Stop the vehicle, switch off the engine, and check the level of the brake fluid.
WARNING
If the warning light
lights up together with the warning light
» page
37,
Antilock brake system (ABS),
a specialist garage.
A fault to the ABS system or the braking system can increase the vehi-
cle's braking distance – risk of accident!

Seat belt warning light

Read and observe
on page 34 first.
illuminates - the driver or front passenger has not fastened the seat belt.
The indicator light
goes off after the respective seat belt is fastened.
At a speed of more than approximately 20 km/h the warning light
and an audible warning sounds at a time.
If the seat belt is not fastened by the driver or front passenger during the next
approx. 2 seconds, the warning signal is deactivated and the warning light
lights up permanently.
stop driving! Seek help from
flashes

Alternator

Read and observe
on page 34 first.
illuminates - while the engine is running the battery is not being charged.
Seek help from a specialist garage.
CAUTION
If in addition to the symbol
the symbol
stop driving- risk of engine damage! Switch off the engine and seek assis-
tance from a specialist garage.

Door open

Read and observe
on page 34 first.
illuminates - one or more doors are open.
On vehicles with MAXI DOT display, this indicator is replaced by a vehicle icon
on the display
» page 42
.

Coolant

Read and observe
on page 34 first.
illuminates or flashes - the coolant temperature is too high or the coolant
level is too low.
Check coolant! Owner's manual!
Stop the vehicle, switch off the engine, check the level of the coolant, and
refill the coolant if necessary.
If the coolant level is within the specified range and the warning light
nated again after ignition on, then there may be a malfunction of the cooling
fan.
Switch off the ignition.
Check the fuse for the radiator fan, replace if necessary.
If the coolant level and the fan fuse are OK and the warning light
again after ignition on
do not continue to drive!
Seek help from a specialist garage.
» page
35lights up while driving,
illuminates
Instruments and Indicator Lights
illumi-
35

Advertisement

Table of Contents
loading

Table of Contents