Start-Stopsystem - Skoda Yeti 2015 Operating Instructions Manual

Hide thumbs Also See for Yeti 2015:
Table of Contents

Advertisement

Problems starting the engine
Read and observe
and
The key in the vehicle cannot be verified
If the key in the vehicle cannot be verified, then engine cannot be started by
pressing a button.
The one of the following messages is shown in the information cluster display.
Key not found.
NO KEY
The reasons for this may be as follows.
The battery in the key is almost out of charge.
The key is malfunctioning
There is interference in the signal between the system and the key (strong
electromagnetic field).
Try to start the engine by pressing the knob with the key
System fault
If the following message appears on the display of the instrument cluster
there is a system malfunction.
Keyless faulty.
CHECK KEYLESS
Try to start the engine by pressing the knob with the key
CAUTION
The key can only be verified if it is in the vehicle. It is therefore not always nec-
essary to know where the key is.
Fig. 122
Starting the engine - Press the
button with the key
on page 117 first.
» Fig.
122.
» Fig.
122.
Note
When attempting to start, the key bit must be pointed towards the button
» Fig.
122.
If engine fails to start after pressing the button with the key, seek specialist
help.

START-STOPsystem

Introduction
This chapter contains information on the following subjects:
Operation
Manually deactivating/activating the system
Information messages
The START-STOPsystem (hereinafter referred to only as system) saves fuel
and reduces harmful emissions and CO
If the system determine that the engine is not needed when the vehicle stops
(e.g. at the traffic lights), it turns off the engine and starts it again when mov-
ing off.
Operation
For the system-dependent automatic engine shut-down when stopping to op-
erate, the following conditions must be met.
For vehicles with manual transmission, the shift lever is in the neutral po-
sition and the clutch pedal is not depressed.
For vehicles with automatic transmission the brake pedal is to be de-
pressed.
The driver's door is closed.
discharge.
2
Fig. 123
Prompt in the MAXI DOT display
Starting-off and Driving
119
120
120
119

Advertisement

Table of Contents
loading

Table of Contents