Maxi Dot Display; Fig. 28 - Skoda Yeti 2015 Operating Instructions Manual

Hide thumbs Also See for Yeti 2015:
Table of Contents

Advertisement

Confirm the set value, or wait several seconds; your settings will be saved
automatically.
The speed limit can be adjusted from 30 km/h to 250 km/h in 5 km/h incre-
ments.
Adjusting the speed limit while the vehicle is moving
Select the menu item Speed warning at () or  () and confirm.
Drive at the desired speed.
Confirm the current speed as the speed limit.
The set speed limit can be manually adjusted later if needed.
Deactivate speed limit
Select the menu item Speed warning at () or  () and confirm.
Confirm the stored value of the speed limits.
The speed limit will be disabled.
The set speed limit value remains stored even after switching off the ignition.
Memory

Fig. 28

Multi-function display - memory display
Read and observe
on page 43 first.
The following data will be saved in two stores 1 and 2.
Average fuel consumption.
Distance driven.
Average speed.
Driving time
Display of the selected memory in the display at position
"1" - Single-trip memory
The memory collates the driving information from the moment the ignition is
switched on until it is switched off.
New data will also flow into the calculation of the current driving information if
the trip is continued within 2 hours after switching off the ignition.
If the trip is interrupted for more than 2 hours, the memory is automatically
erased.
"2" - Long-term memory
The memory gathers data from any number of individual journeys up to a total
of 19 hours and 59 minutes or 1 999 kilometres driven (), and up to a total of
99 hours and 59 minutes or 9 999 kilometres driven ().
The memory is deleted when either of these limits is reached and the calcula-
tion starts all over again.
Unlike the single-trip memory, the total-trip memory is not deleted after a pe-
riod of interruption of driving of 2 hours.
Select memory
Select the driving data information desired.
Confirm details again to select the desired memory.
Resetting
Select the driving data information desired.
Select the desired memory.
Reset the selected memory by holding pressed.
Note
Disconnecting the vehicle battery will delete all memory data.

MAXI DOT display

Introduction
This chapter contains information on the following subjects:
Main menu
Operation using the operating lever
Operation using the multi-function steering wheel
» Fig.
28.
A
Menu item Navigation
Menu item Audio
Menu item Telephone
46
46
47
47
48
48
45
Information system

Advertisement

Table of Contents
loading

Table of Contents