To Prevent The Outdoor Unit From Falling Over; Mounting The Indoor Unit; To Install The Indoor Unit - Daikin Altherma Installer's Reference Manual

7 Installation
7.2.4 To prevent the outdoor unit from falling
over
In case the unit is installed in places where strong wind can tilt the
unit, take following measure:
1 Prepare 2 cables as indicated in the following illustration (field
supply).
2 Place the 2 cables over the outdoor unit.
3 Insert a rubber sheet between the cables and the outdoor unit
to prevent the cable from scratching the paint (field supply).
4 Attach the cable's ends. Tighten those ends.
7.3

Mounting the indoor unit

7.3.1

To install the indoor unit

CAUTION
Do NOT grasp the piping to lift the indoor unit.
1 Lift the unit from the package.
Installer reference guide
30
1
60kg
2 Remove the 4 screws from the bottom of the unit. Unhook and
remove the side plates.
3
3 Put the installation pattern (see packing) on the wall and follow
the steps as shown below.
1 2
4 Lift the unit.
1
5 Tilt the top of the unit against the wall at the position of the 2
inserted screws.
6 Hook the unit against the wall.
ERLQ004~008CAV3 + EHBH/X04+08CA
2
3
1
4x
2x
3 4
Daikin Altherma - Low Temperature Split
4P313774-1C – 2012.11