Opticon H-32 User Manual page 32

The Status tab displays the following sections:

Status - Wi-Fi

Status – Bluetooth
6.1.1.1 Wi-Fi Status
Status
Down
Disabled
Not Associated
Associated
Connected to [SSID] The radio is connected to the named SSID.
Note: If the Encryption type is set to WEP or Open (None), it can communicate
(send data) while in the Associated state.
IP Displays the IP address of the H-32 Wi-Fi connection.
Signal Strength displays the signal strength (or RSSI) in dBm.
6.1.1.2 Bluetooth Status
Status
Down
Disabled
Not Connected
Paired, Not Connected
Connected
H32 User Guide
Description
The radio is not recognized by Laird software and therefore is not
associated or authenticated.
The radio is disabled. To enable the radio, check the Wi-Fi check
box located on the Configuration window. When the radio is
disabled, it does not attempt to make a connection to an access
point.
The radio has not established a connection to an access point.
The radio has established a connection to an access point but is
not EAP authenticated. The radio cannot communicate unless it is
associated and EAP authenticated.
Description
The radio is not recognized by Laird software and therefore is
not associated or authenticated.
The radio is disabled. To enable the radio, check the Bluetooth
check box located on the Configuration window. When the
radio is disabled, it does not attempt to make a connection to
an access point.
The radio is not connected to any Bluetooth devices.
The radio has found a Bluetooth device but is not paired with
it.
The radio is connected to a Bluetooth device.
Wi-Fi and Bluetooth
32