Opticon H-19 Series Quick Start Manual

1. Introduction
Views of the Device
7
1 29
9 10
8 11
24
2
30
25
3
26
4
12
5
27
6
31
28
13 14
15 16
32
17 18
19
20
21
22
23
1. Introduction
1 Stylus Write, draw, or make selection on the touch screen.
2 Scan key (left) Press the key to scan and decode bar code/2D code.
3 Record key Press and hold this key to record a voice note.
4 Volume up Press the Volume up button to turn up the PDA receiver volume.
5 Volume down Press the Volume down button to turn down the PDA receiver volume.
6 Reset button* Press the Reset button with stylus to soft-reset your device.
7 Scanner
Point the reading window of the scanner in the direction of bar code/ 2D code.
8 Wi-Fi/Bluetooth LED
Indicates Wi-Fi/ Bluetooth Status.
9 Telephone receiver
Listen to a phone call here.
10 GSM/Battery LED Indicates GSM/Battery LED.
11 Power button Power on or off the device.
12 Display 2.8-inch TFT LCD with touch screen.
13 Soft key (left) Performs the command shown in the label above the button.
14 Soft key (right)
Performs the command shown in the label above the button.
Helps you to perform special functions by using the keypad. For more information on
15 Fn key
how to use the Fn key, refer to "ch2.2 Input Methods".
16 Backspace Press this key to erase the letter on the left side of the cursor.
17 Talk key Press this key to dial or answer a call.
18 End key End a call or close Phone application.
Press the multi directional control up, down, left, or right to move through menus; carry
19 5-way navigation key
out the selection by pressing the center button.
20 Numeric keypad
Enter numbers or letters by the numeric keypad.
Connect the connect pins of the device and the cradle (if any) for recharging the
21 Connect pins
battery.
22 Microphone Speak into the microphone when talking on the phone or recording a voice note.
23 Eyelet for wrist strap (1) Fix a wrist strap here.
24 Scan key (right) Press the key to scan and decode bar code/ 2D code.
25 Eyelet for wrist strap (2) Fix a wrist strap here.
26 Mini-SD card slot
Insert a mini-SD card to expand device memory.
27 Mini USB connector
Mini USB connector for PC sync and battery charging.
28 Earphone Jack Connect a 2.5 mm Earphone.
29 Speaker Listen to audio media or listen to a phone call hands-free.
30 Screw hole Fasten the provided strap set here with screws.
31 Cover latch Slide both of the cover latches to remove the battery cover.
32 Battery cover Uncover it to place battery and SIM card.
*Be sure to save all data in your device and then press the Power button to
switch your device off before resetting your device.
1. Introduction
Notification LEDs
The device has 2 notification LEDs: the left is Wi-Fi/Bluetooth LED and the right is
GSM/Battery LED.
Bluetooth/Wi-Fi LED tells you about the device's Bluetooth/Wi-Fi status:
Color Bluetooth on Wi-Fi on
Green Off Blink
Blue Blink Off
Green and blue blink alternately while both Bluetooth and Wi-Fi are on.
GSM/Battery LED lets you know that you have unanswered calls or tells you about
the device's GSM/battery status:
Missed Call/ Low GSM on GSM on (battery
Color Charging
Power (battery full) low)
Red Blink Off Blink Off
Orange Off Off Off Constantly on
Green Off Blink Off Off
Accessories
Manu al QSG
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
17
1. Introduction
1 AC adapter 10 Strap set
2 Stereo headset 11 UK plug
3 USB cable 12 EU plug
4 Getting started CD 13 AU plug
5 User manual/Quick guide 14 Stylus
6 Pouch 15 Additional stylus
7 Neck strap 16 Stylus holder
8 Belt clip 17 Stylus string
9 Battery
Installing the SIM Card and Battery
If you want to use phone features, you must install a Valid SIM card.
1. Press the battery cover downward and slide one of the cover latches down at the
same time.
2. Repeat the same steps to unlock another cover latch.
Unlock
3. Lift the battery cover as the diagram shown below.
the latch
Unlock
the latch
Please do not remove the battery cover when your device is in use;
otherwise, the device power will be shut off automatically and unsaved
data may be lost.
4. Pull the plastic ribbon to remove the battery.
1. Introduction
5. Place the SIM card in the SIM card slot with the gold contacts facing down. The
SIM card's cut-off corner should match the cut-off corner in the SIM card slot.
6. Press the battery down forcefully into the battery slot.
2
1
7. Angle the battery cover as shown in the diagram and close the
battery cover.
8. Press the battery cover downward and slide one of the cover
latches up at the same time.
9. Repeat the same steps to lock another latch.
Lock the
latch
Lock
the latch
Please avoid placing the battery as the direction shown
in the figure. This may damage the battery switch (the
part circled in red) in the battery slot.
The device contains a rechargeable Li-ion polymer
battery completely discharged and should be charged
for at least 8 hours before first use.
6061B0242402