Power Scheme; Input Panel / Virtual Keyboard - Opticon H-32 User Manual

Recoveryrefresh Specifies the time, in milliseconds, until next synchronization if the
DWORD previous attempt failed. Default recovery refresh time is 5 minutes.
Note: Both SNTP and NTP are clients of the User Datagram Protocol (UDP). The
UDP port number assigned to NTP is 123.

3.5 Power scheme

The power scheme is used for power control. There are three different states that the
power scheme supports. The settings for the power scheme can be set for AC powered
(charging) or battery powered operation. To get to the power scheme tap
Panel -> Power -> Schemes tab.
State Description
User Idle After the user idle timer has expired the H-32 will shut down a number
of services e.g. the backlight.
System Idle After the System idle time has expired more services will be shut down.
Suspend When the suspend timer has expired the H-32 will be turned off. This
has the same effect as if the user pressed the power button for a short
time.
The power scheme timers work cumulative. This means that the system idle timer can
only expire after the user timer has expired. When all three idle states are set to one
minute the H-32 power scheme operate like this:

User Idle – after 1 minute inactivity

System idle – after 2 minutes of inactivity

Suspend – after 3 minutes of inactivity

3.6 Input Panel / Virtual keyboard

The input panel or also called virtual keyboard can be used to input data. The input
panel will come up automatically when the cursor is placed into an edit field. The
keyboard can be controlled from the taskbar. If the automatic mode of the input panel is
not wanted a registry key needs to be changed.
Input panel registry setting
[HKEY_CURRENT_USER\ControlPanel\Sip]
"TurnOffAutoDeploy"=dword:00000000
H32 User Guide
Using the H32
-> Control
19