Statement Of Agency Compliance - Code CR1200 User Manual

Statement of Agency Compliance

The CR1200 has been tested for compliance with FCC regulations and was found to be compliant with all
applicable FCC Rules and Regulations.
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, this
device must not be co-located or operate in conjunction with any other antenna or transmitter.
CAUTION: Changes or modifi cations not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
The CR1200 has been tested for compliance to CE standards and guidelines and was found to conform
to applicable CE standards, specifi cally the EMC requirements EN 55022 Class BRadiated Emissions and
Class B Conducted Emissions.
NOTE: This equipment has been tested and found to comply with the limits or a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Save Settings
C003525_03_CR1200 User Manual i