Table of Contents
Advertisement
NOTICE
Be careful NOT to distort the shape of the backside of the
user interface by overtightening the mounting screws.
3 Cut off a 2 wire conductor.
4 Connect the wires to the user interface as shown below.
From the rear
PCB
1x
b
a Notch this part for the wiring to pass through with
nippers etc.
b Secure the wiring to the front part of the casing
using the wiring retainer and clamp.
5 Reinstall the faceplate onto the wallplate.
NOTICE
Be careful NOT to pinch the wiring when attaching the
frontplate to the unit.
To fix the user interface to the wall in case of
installation as room thermostat
1 Insert a screwdriver into the slots underneath the user interface
and carefully separate the faceplate from the wallplate.
NOTICE
The PCB is mounted in the faceplate of the user interface.
Be careful NOT to damage it.
2 Fix the wallplate of the user interface to the wall.
3 Connect the wires to the user interface as shown below
From the rear
PCB
1x
b
From the left
PCB
1x
a
b
ERLQ004~008CAV3 + EHVH/X04+08S18CA + EHVH/X08S26CA
Daikin Altherma - Low Temperature Split
4P313775-1C – 2012.11
a
a
From the top
a
b
PCB
1x
b
From the top center
b
PCB
1x
b
a Notch this part for the wiring to pass through with
nippers etc.
b Secure the wiring to the front part of the casing
using the wiring retainer and clamp.
4 Reinstall the faceplate onto the wallplate.
NOTICE
Be careful NOT to pinch the wiring when attaching the
frontplate to the unit.
7.6.7
To connect the shut-off valve
1 Connect the valve control cable to the appropriate terminals as
shown in the illustration below.
NOTICE
Wiring is different for a NC (normal closed) valve and a NO
(normal open) valve.
NO
6 7
5
X2M
X2M
X1M
M2S
2 Fix the cable with cable ties to the cable tie mountings.
7 Installation
a
NC
5
7
6
X1M
M2S
Installer reference guide
39
Advertisement
Table of Contents
