Table of Contents
Advertisement
Getting started
Registering additional cordless
handsets at the base station
Switching the cordless handset
on and off
During the switching on process, a
progress bar appears on the display.
14:34
Monday 21/03/2011
Light
Door call
The following display appears during
the registration process:
Searching base
Please wait
After selecting the base, the fol-
lowing display appears:
Registering handset
Please wait
• As soon as the base station has
been found, confirm the located
base with the left-hand display
button OK.
The cordless handset is now in the
ready status.
After successful registration, the
base station is locked again for new
registrations. This is indicated by a
continuous green LED light.
• To register additional cordless
handsets, disconnect the base sta-
tion from the mains power again
and proceed as described above.
Note
The additionally registered cord-
less handsets are synchronized to
the correct date and time and the
same intercom settings as cordless
handset 1.
Procedure:
• In order to switch on the handset,
press the red End call button for
around 1 second.
• The handset automatically acti-
vates the power save mode if it is
in the idle status for more than 2
minutes.
• The display switches off.
• A hibernating handset switches
back on automatically as soon as it is
placed in the charging cradle.
• The display terminates the power
saving mode automatically after
around 1 second as soon as it is
removed from the charging cradle.
7
Advertisement
Table of Contents
