Resetting The Base Station - SSS Siedle Siedle Scope S 850-0 Operating Instructions Manual

Main menu
Settings

Resetting the base station

When the base station is RESET, it
returns to the as-delivered status, in
other words:
• The PIN is rest to 0000
• All registered cordless handsets
are deleted
• The door forwarding function is
deleted
• The Doormatic function is deleted
• All the In-Home functions are
deleted
(Print out the settings from the BPS
or make a note of the functions acti-
vated prior to the RESET and enter
the same settings when repeating
the registration process.)
34
In-Home
Prog.
Line
Power
Procedure:
• Unplug the patch cable for the
In-Home bus at the base station.
• The base station can continue to
be supplied with power during this
process.
• Then press the PROG button (using
a paper clip or similar) and hold it
in place.
• While you continue to hold down
the PROG button, plug the patch
cable back into the In-Home bus.
• When the Prog LED flashes twice,
you can release the PROG button.
The status LED on the front of the
base station flashes to indicate that
the RESET is in progress.
• As soon as the status LED flashes
green, the RESET process is com-
pleted.
• You can now reregister the cord-
less handsets which you had previ-
ously deregistered.
If you did not deregister your cord-
less handsets before, the following
display appears:
Base not found
• Then select the entry Deregister
handset in the main menu under
system settings.
• In answer to the question Do you
want to deregister the handset?
confirm with Yes.
• Confirm by pressing the left-hand
display button OK.
The following question appears in
the display:
Deregistration failed. Register to
different base?
• Confirm by pressing the display
button OK.
The registration process is started.
As soon as the base station has been
located, you can begin to use the
cordless handset.