Registering Additional Cordless; Getting Started - SSS Siedle Siedle Scope S 850-0 Operating Instructions Manual

Getting started

Registering the cordless handset
at the base station
Your cordless handset is already
registered in the set: The left-hand
signal strength symbol indicates the
strength of the connection in the
status bar at the top.
Charging the cordless handset
battery
After unpacking the cordless
handset, the battery charge status
must be checked. This is delivered
fully charged, but discharge may
have occurred during storage and
transport.

Registering additional cordless

handsets at the base station
Up to 8 cordless handsets can be
operated in parallel at the base sta-
tion. The cordless handset supplied
as standard in the set is designated
handset 1. Other cordless handsets
are numbered through in the order
in which they are registered.
The prescribed designations for
handsets 1 to 8 cannot be edited.
6
14:34
Monday 21/03/2011
Base not found
Registration
Would you like to register
the handset?
OK
Procedure:
• If the display of the cordless
handset shows the following mes-
sage highlighted in yellow: Base not
found, then connect the base sta-
tion to the mains power.
• Also connect the charging cradle
with the cordless handset to the
mains power.
• As soon as the base station has
been located, you can begin to use
the cordless handset.
• If the registration has failed, con-
tact your specialist dealer or elec-
trical installer.
Note
Please observe the safety and dis-
posal instructions relating to the
rechargeable battery.
This is a li-polymer battery with the
following performance capability:
• Standby: appr. 100 hours
• Video link: appr. 3 hours
• Audio link only: up to
appr. 10 hours
Procedure:
• To register an additional cordless
handset, disconnect the base station
from the mains power.
• Reconnect the base station to the
mains power.
• The base station now has a
3-minute window in which an addi-
tional cordless handset can be reg-
istered. This is indicated by a green
flashing LED at the top.
• Also connect the charging cradle
with the cordless handset to the
mains power.
• The following message appears on
the display on the additionally regis-
tered cordless handset:
• Would you like to register the
handset?
• Confirm by pressing the left-hand
display button OK.