Machine Operation - Pacific Proteus 26 Operating & Maintenance Instructions

1) Connect machine connector (2) to the battery
connector (1).
2) Turn key (1) clockwise to ON. Signal light (3)
will illuminate indicating that the batteries are
charged. If the indicator is flashing the
batteries need to be charged.
3) Turn on the water solenoid valve switch (3).
4) Turn on the brush motor switch (5).
5) Turn on the vacuum motor switch (4).
6) Adjust the flow rate of the cleaning solution
with lever (1). There should be enough
solution to wet the floor uniformly, but not so
much that the water gets past the splash
guard. Remember that the correct solution
quantity depends on the type of floor, the dirt
level and the scrubbing speed.
7) Release and lower lever (2) to lower the brush
base.
8) Lower the squeegee using lever (3).
9) Release parking park lever (4).
During the first few yards of operation, check that
the quantity of the cleaning solution is sufficient
to wet the floor and that the squeegee dries the
floor surface.

MACHINE OPERATION

Page 9 of 17