Recovery Tank - Pacific Proteus 26 Operating & Maintenance Instructions

8) ADJUSTING SQUEEGEE HEIGHT
The height from floor to squeegee should be
adjusted based on blade wear. Rotate the
knobs (2) counter-clockwise to lift squeegee
and clockwise to lower it.
NOTE: Rotate the right and left adjusting
knobs until the squeegee is positioned parallel
to the floor.
9) ADJUSTING SQUEEGEE INCLINATION
During operation the rear squeegee blade is
most efficient when bent backwards roughly
ths
3/16 of an inch along its entire length. To
increase the blade bending in the center of the
squeegee, tilt the squeegee body backward by
turning the adjuster screw (1) in the image
above, counter-clockwise. Conversely, turn
the adjuster screw (1) clockwise to increase
the bending at the outside edges of squeegee
blade.

10) RECOVERY TANK

Open the lid and confirm the following
connections are secure:
a) The vacuum cover (2) is securely attached.
Align the notches and rotate the cover
clockwise to close. The vacuum hose
must also be attached.
b) Confirm that the squeegee hose (1) is
properly connected.
c) Confirm that the drain hose plug, which is
located at the front of the machine, is
closed.
MACHINE PREPARATION
Page 7 of 17