Charging The Batteries - Pacific Proteus 26 Operating & Maintenance Instructions

3) BATTERY INSTALLATION (Cont.)
The battery charger's connector fits into
the battery connector (1).

4) CHARGING THE BATTERIES

NEVER ALLOW THE BATTERIES TO COMPLETELY DISCHARGE. Recharge them within a
few minutes after the battery indicator starts flashing. Never leave the batteries completely
discharged, even if the machine is not being used.
WARNING! When charging the batteries, follow all the instructions provided with
this manual and the battery charger. Trained staff must carry out the installation
and maintenance operations.
WARNING! Fire Danger: Lead acid batteries generate gases that can cause an
explosion. Keep sparks and flames away from batteries. NO SMOKING!
WARNING! To prevent an explosion, charge the batteries only in an area with
good ventilation.
WARNING! Always wear eye protection and protective clothing when working
near batteries.
When charging the batteries, keep the recovery tank lifted by supporting the prop as shown in
the figure below.
Turn the key to the OFF position. Connect the DC connector on the charger to the DC battery
connector. Connect the AC charger plug to a receptacle that has the correct voltage and
frequency for your charger. Make sure the receptacle is connected to the electrical ground.
MACHINE PREPARATION
Page 5 of 17