Charge And Install The Battery - Humminbird PiranhaMAX 155 Installation And Operation Manual

Charge and Install the Battery

In this procedure, you will charge and then install and secure the battery.
1. Charge the battery, using the included battery charger, until it is fully
charged as indicated by the LED on the charger. Charging usually
requires 8 continuous hours, but may vary depending on your
configuration.
NOTE: Some international models may not include a battery or battery charger.
2. Open the bottom back zipper on the portable case, and install the
battery in the battery well. While holding the tie-down straps out of the
way, make sure the power cable is fitted snugly into the slot in the well
so that they battery does not rest on it (see the illustration Installing
the Battery).
Installing the Battery
Figure 42
3. Pull the battery tie-down straps over the top of the battery and connect
both ends of each strap over the top, making sure that the straps are
pulled tight around the battery and that the battery is seated securely
in the battery well.
4. Zip up the back opening.
NOTE: Do NOT connect the power cable to the battery at this time. You should
wait until just before fishing to connect the power cable to the battery.
Tying Down the Battery
31
PiranhaMAX Portable Case Assembly