Assemble The Portable Case - Humminbird PiranhaMAX 155 Installation And Operation Manual

Assemble the Portable Case

In this procedure, you will install the base assembly into the portable case.
1. Unzip the largest opening on the front of
the portable case.
2. Insert the base assembly into the
portable case, so that the PiranhaMAX
control head is facing out of the case. For
best results, pull the case over one
shoulder of the handle at a time.
3. Adjust the case so that you can easily
grab the handle, through the fabric
handhold inset, from the outside top of
the portable case.
PiranhaMAX Portable Case Assembly
Installing the Base into the Case
Pulling the Case over the Handle
Holding the Portable Case
Figure 41
30