Assemble the Transducer Mounting Bracket
In this procedure, you will assemble the portable transducer mounting bracket.
1. Line up the two ratchet pieces at position 1 so that the beads are
aligned with the rib on the transducer. See the illustrations below.
Transducer Knuckle Positions
Figure 43
2. Assemble the other transducer parts as shown (see the illustration
Assembling the Portable Bracket below). Hand tighten only!
suction cup
PiranhaMAX Portable Case Assembly
knuckle
Assembling the Portable Bracket
washer
wing nut
Figure 44
Ratchets Placed in Position 1
rib at
position
1
portable transducer
assembly
32
beads
ratchet
Phillips head
screw
bolt
ratchet